Colad Foil Applicator 6950: Clean Wall Protection Made Simple
The Colad Foil Applicator 6950 is designed for quick, uniform, and bubble-free application of Film4Booth — the dry protective film for spray booth walls. Perfect for keeping your booth clean, maintaining brightness, and reducing cleaning time between jobs.
Why Choose the Colad Foil Applicator 6950?
Faster application, cleaner overlaps, and consistent results: When combined with Film4Booth, this applicator ensures long-lasting wall protection, reduces booth maintenance time, and guarantees bright, professional paint conditions.
Product Overview & Accessories
| Component | Purpose | Notes / Specs |
|---|---|---|
| Foil Applicator 6950 | Applies protective film to spray booth walls | Designed for Film4Booth; manual operation. |
| Film4Booth 6860 | Transparent, self-adhesive wall film (4 layers) | 90 cm × 84 m (~75.6 m²); antistatic; paint adhesion coating. |
| Film Dispenser 6900 | Assists smooth unwinding & film handling | Recommended for consistent wall coverage. |
| Adhesive Tape 6880 | Seals film overlaps | Seal overlaps with booth adhesive tape to prevent contamination. |
| Magnetic Foil Cutter 2070 | Clean cutting directly on the wall | Ensures precise, safe trimming of film edges. |
Recommended Base Settings (Reference Values)
- Ensure surface is clean and grease-free.
- Apply dry, by hand with applicator & dispenser.
- Film size: 90 cm × 84 m (~75.6 m² coverage).
- 4 layers for long-term protection; layers are numbered for easy removal.
- Seal overlaps with adhesive tape 6880.
- Film4Booth is non-conductive; check ATEX suitability if required.
Pro Workflow: Apply the Film in 6 Steps
- Clean the booth thoroughly (dust- and grease-free).
- Load the roll into the Film Dispenser 6900 and position the starting edge.
- Use the Foil Applicator 6950 to press down evenly from top to bottom, pushing out air bubbles.
- Align the next strip with 2–3 cm overlap and seal with Adhesive Tape 6880.
- Trim edges neatly using the Magnetic Foil Cutter 2070.
- When dirty, simply peel off the outer layer — the next one is ready underneath.
Troubleshooting
Increase even pressure; push bubbles toward the edges.
Clean the surface again; peel back section, wipe, and reapply.
Seal joints with Adhesive Tape 6880.
Peel off the top layer; next layer is pre-applied.
Maintenance (Quick & Easy)
- Peel off dirty top layer regularly.
- Check and reseal overlaps if needed.
- Keep the foil cutter clean and sharp.
- Wipe dispenser and applicator free from adhesive residue.
- Store film rolls in a dry, UV-protected area.
FAQ
What is the Foil Applicator 6950 used for?
For fast, even application of Film4Booth protective film on spray booth walls.
Which film fits best?
Film4Booth 6860 (transparent, self-adhesive 4-layer protective film).
How much area does one roll cover?
Approx. 75.6 m² per roll (90 cm × 84 m).
How long does the protection last?
Up to 1 year or 1,000 booth cycles, depending on use.
How do I remove the film?
Peel off layer by layer — numbered sheets make it simple.
Conclusion
With the Colad Foil Applicator 6950 and Film4Booth, you get a proven dry protection system: spotless walls, stable lighting, and less booth cleaning — for professional results day after day.
