Manufacturer no.:
4010
Underbody protection M80 black - Can be painted over
€12.45*
% €15.83* (21.35% saved)Ready for shipping in 1-3 days
Also interesting
Product information
Specifications
1 L. Can with spray connection (suitable for ± 2.5 m²). 2 versions: Black and grey.
This coating offers excellent protection against weathering, stone chips and rust and is sound-absorbing
Made of rubber and synthetic resin. Once the applied coating has dried, it can be painted over immediately. The coating offers excellent protection against weathering and stone chipping.
Features and benefits of underbody protection M80
- Very good resistance to weathering, spray water and abrasion.
- Very good adhesion to a wide range of substrates.
- Extremely high wear resistance Preparation and processing
- Can be applied as a stone chip and corrosion protection layer.
- On bumpers, front and rear skirts, door sills and body underbody as well as a sound-absorbing product in wheel arches.
- For cars, lorries and buses.
- Shake well before use.
- The surface to be treated must be clean, dry and free of rust, dust and grease.
- Can be applied with a U-protection gun at an air pressure of 3-6 bar.
- Coating without bleeding through.
- Can be recoated with standard 2K and base coats after approx. 60 to 90 minutes (depending on the layer thickness, temperature and humidity). If you are using a 2-component paint, we advise you to apply a coat of primer and to paint this after complete drying.
- Optimum spraying distance: 30 cm
- Cleaning dirty surfaces and equipment: when "fresh" with solvents.
Technical data underbody protection M80
- Packaging: 1 litre. Can with spray connection
- Packaging unit: Carton with 12 x 1 L.
- Shelf life: 2 years (storage between 10°C and 20°C)
- Application: ± 0.7 kg/m² or ± 0.7 litres/m²
- Consistency: Liquid, good run-off resistance
- Temperature resistance (cured): 25°C to +80°C
- Resistance (20°C), cured: Water, salt spray, oil, weak bases and acids.
- Initial drying (20°C, 65% RL): Approx. 45 min. (±700 μ wet)
- Complete drying (20°C, 65% RL): Approx. 2 hours (±700 μ wet)
- Forced drying (60°C): Approx. 45 min (± 700 μ wet)
- Paintability (20°C, 65% RL): Two-component paints with high solids content: Possible after drying, primer recommended. Basecoat system: Possible after drying. Water-based system: Possible after drying.
- Adheres well (without pre-treatment): to a variety of clean, dry, dust and grease-free substrates. It is advisable to carry out an adhesion test before application.
More information
- Product number: 1006183
- Manufacturer: Colad
- EAN: 8714247001448
Reviews
Register
