DREHKOPF E-D Quick-Sieve Dispenser: Complete Guide for Perfect Coatings
Learn how to achieve optimal coating results with the professional rotating head dispenser system – from correct adjustment to efficient maintenance.
Product Overview: Technical Data in Detail
| Parameter | Specification | Application Area |
|---|---|---|
| Pressure Range | 1.5 - 4.0 bar (reference values) | Fine to standard coatings |
| Material Throughput | Variable depending on nozzle size | Consistent material output |
| Viscosity Range | Wide spectrum | Various materials |
⏱️ Fast Setup Time
Switch between different materials in minutes
🎯 Precise Dosing
Accurate material dispensing without waste
🔄 Easy Cleaning
Minimal downtime thanks to quick maintenance
💡 Pro Tip: Increase Pressure Slowly
Always start with low pressure and increase gradually until optimal spray characteristics are achieved. This avoids excessive material consumption and uneven coatings.
Recommended Basic Settings (Reference Values)
For optimal results, the following basic settings should serve as a starting point:
| Material Type | Pressure (bar) | Nozzle Size | Viscosity |
|---|---|---|---|
| Low-viscosity paints | 1.5 - 2.5 | Small | Low |
| Medium-viscosity coatings | 2.5 - 3.5 | Medium | Standard |
| High-viscosity materials | 3.5 - 4.0 | Large | High |
Pro Workflow in 7 Steps
- System Check: Inspect seals and sieve for damage
- Material Preparation: Adjust coating material to recommended viscosity
- Nozzle Installation: Select suitable nozzle size for material type
- Pressure Setting: Adjust working pressure according to material requirements
- Test Run: Check spray pattern on test surface and fine-tune
- Production Run: Maintain consistent working distance and movement
- Final Inspection: Check and document coating quality
Troubleshooting: Solve Common Problems
Uneven Spray Pattern
- Increase or decrease pressure
- Check nozzle for contamination
- Adjust material viscosity
Material Dripping from Nozzle
- Release system pressure after the work is done
- Check seals for wear
- Look for cleaning residue
Reduced Material Flow
- Check sieve for clogging
- Replace material filter
- Increase pressure
Excessive Material Consumption
- Reduce working pressure
- Test smaller nozzle size
- Optimize spraying technique
Maintenance Plan for Maximum Lifespan
- Daily: Complete cleaning after use, check seals
- Weekly: Check sieve and filter for wear
- Monthly: Lubricate all moving parts, replace seals
- Quarterly: Full disassembly and inspection of all components
- If problems occur: Immediate shutdown and troubleshooting
Ready for Perfect Coatings?
Discover the DREHKOPF E-D Quick-Sieve Dispenser for your professional requirements
Discover Product →FAQ – Frequently Asked Questions
What viscosity is ideal for the system?
The system handles a wide viscosity range. For best results, materials should fall within the manufacturer’s recommended viscosity range.
How often should seals be replaced?
For daily use, monthly replacement is recommended. For aggressive materials or heavy operation, shorter intervals may be necessary.
Can the system handle abrasive materials?
Yes, but with adjusted maintenance intervals. Wear parts should be checked more frequently and replaced if necessary.
Which cleaning agents are suitable?
Use compatible solvents that do not damage the dispenser material. Avoid aggressive chemicals.
How do I set the optimal working pressure?
Start with the recommended reference values and adjust the pressure based on spray pattern and material flow.
Conclusion
The DREHKOPF E-D Quick-Sieve Dispenser offers precise dosing and flexible settings, providing ideal conditions for professional coating results. With correct settings, a systematic workflow, and regular maintenance, you will achieve consistently high quality with minimal material consumption.
